Baro Sensor problem
Moderator: snoopyjon
5 posts
• Page 1 of 1
Baro Sensor problem
by Kizior » Tue Feb 10, 2015 11:41 am
I've got a Baro Sensor problem in my SP1. There's one about 1 second long FI lamp flash when I check for errors so it's error no 10. I've checked voltages on the sensor and they'se OK. I've replaced the baro sensor to another one and I was ok for about 5 minutes. No 10 error came back. Somebody can help ?
--
Regards Piotr
Regards Piotr
- Kizior
- Posts: 14
- Joined: Tue Feb 10, 2015 10:03 am
- Location: Poland
Re: Baro Sensor problem
by sparkysp2 » Tue Feb 10, 2015 7:55 pm
Have you cleared the error code ..
Always keep it black side down and shiney side up....
-
sparkysp2 - Posts: 416
- Joined: Sat Jun 18, 2011 8:53 am
- Location: Hampshire
Re: Baro Sensor problem
by Kizior » Thu Feb 12, 2015 7:47 am
Yes. And it shows again.
--
Regards Piotr
Regards Piotr
- Kizior
- Posts: 14
- Joined: Tue Feb 10, 2015 10:03 am
- Location: Poland
Re: Baro Sensor problem
by Kizior » Tue Feb 16, 2016 12:20 pm
It was caused by leaking fuel pressure regulator and vacuum loss (for information)
--
Regards Piotr
Regards Piotr
- Kizior
- Posts: 14
- Joined: Tue Feb 10, 2015 10:03 am
- Location: Poland
Re: Baro Sensor problem
by Wyvern971 » Mon Mar 14, 2016 2:35 pm
Kizior wrote:It was caused by leaking fuel pressure regulator and vacuum loss (for information)
Thanks for the update
Out of interest, how did you figure it out?
- Wyvern971
- Posts: 277
- Joined: Fri Feb 25, 2011 4:16 pm
- Location: London
5 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 2 guests